Table of Contents
Advertisement
Programming
Register radio pendant
Register the pendant only after having connected the telephone to the power supply
system!
You need to register the pendant so that the pendant can address the receiving equipment
integrated in the telephone. At the same time, this procedure is applied to assign the dis-
tress radio call numbers to the pendants. You can enter the memory locations in a variable
sequence. The distress radio call numbers will then be called in the entered sequence.
#
CAUTION
In the following procedure it is not the call number itself which is
allocated but instead the memory location in which the number is stored
(see table on the page before).
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter the code of the corresponding pendant
code 381 for pendant 1
code 382 for pendant 2
code 383 for pendant 3. If desired, continue until code
388 for pendant 8.
The display shows:
Press the button of the pendant.
The pendant's red LED is lit.
Press the button of the
pendant again.
The pendant's red LED is lit.
Enter the memory locations of the distress radio call numbers
consecutively - via the numeric keys (e. g. memory locations
1 2 3 6).
Press the P key. The setting is stored.
33
P
P
P
Advertisement
Table of Contents
