Replacing Modules - Siemens Simovert 6SE70 Series Operating Instructions Manual

https://www.aotewell.com
Maintenance
8.2.2

Replacing modules

The modules contain electrostatically sensitive devices. You must discharge your own
body before touching an electronic module. This is best done by touching a conductive
earthed object (e.g. a bare metal part of the control cabinet) directly beforehand.
Replacing modules in the electronics box
(option)
♦ Undo the securing screws of the modules
above and below the insertion /removal aids
♦ By means of the insertion /removal aids,
carefully pull the module out of the
electronics box, making sure that the module
does not get stuck
♦ Carefully insert the new module in the guide
rails until it moves no further in the
electronics box
♦ Firmly screw down the module with the
securing screws above and below the
insertion / removal aids.
8-4
AoteWell LTD
AoteWell Automation Sales Team
Modules must only be replaced by qualified persons.
Modules must not be removed or inserted under a live voltage.
Non-observance of warning notices can result in death, severe personal injury
or considerable property damage.
S lo t 1 (C U R )
S lot 3 (O ptio n s)
S lot 2 (O ptio n s)
Figure 8.5
Buy Siemens PLC HMI Drives at AoteWell.com
WARNING
CAUTION
Electronics box, equipped with CUR (slot 1)
and options (slots 2 and 3)
Siemens AG
Rectifier/Regenerating Unit
Sales@aotewell.com
09.02
6SE7087-6AK85-1AA0
Operating Instructions
https://www.aotewell.com