Assembly - ELECTRO FREEZE COMPACT Series Operator's Manual

7

Assembly

Figure 7-1 Shaft Seal Lubrication
Figure 7-2 Beater Shaft Assembly
Figure 7-3 Scraper Blade Installation
184592-01
ELECTRO FREEZE Shake Model CS705-M2
Correct assembly of the freezer is
essential to prevent leakage of the
product and damage to the freezer. To
assemble the freezer, you will need an
approved lubricant (such as Compound
7). Make sure all parts of the assemblies
have been washed and sanitized before
assembling. Persons assembling the
freezer must first wash and sanitize their
hands and forearms with an approved
sanitizer.
1. Persons assembling the freezer must
2. Assemble the shaft seal by installing
3. See figure 7-2. Install the shaft seal
4. Place the scraper blades on the
5. See figure 7-3. Insert the assembled
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are in
the "OFF" position and that
the main power supply is
disconnected.
first wash and sanitize their hands and
forearms with an approved sanitizer.
the cup seals (3) on the plastic
washer (4). Apply a moderate amount
of approved sanitary lubricant (such
as Compound 7) to the washer. Do
not allow any lubricant to come in
contact with the bell-shaped rubber
portions of the seal (figure 7-1).
over the rear of the beater shaft. Wipe
off excess lubricant from the beater
shaft.
beater shaft, making sure the blades
are installed properly.
beater shaft into the cylinder by
placing one blade on the bottom of the
cylinder. This will center the beater
and allow alignment with the drive
shaft. Rotate the beater assembly
while pushing, until the shank has
engaged the drive shaft.
—continued
19