Safety; Introduction; Note To Installer - ELECTRO FREEZE COMPACT Series Operator's Manual

1

Introduction

The CS705-M2 Freezer is designed to
produce soft serve ice cream, ice milk,
yogurt, and similar frozen dairy products,
with a product serving temperature
range of 15° to 25ºF (-9° to -4°C). If such
products are prepared from powdered
concentrate, they should be precooled
to 40ºF (4°C) prior to introduction to
the freezer. Use of other products in
this machine is considered misuse (see
Warranty).
This manual has been prepared to assist
you in the proper operation and general
maintenance of the Electro Freeze Model
CS705-M2 freezer.
Make sure all personnel responsible for
equipment operation completely read and
understand this manual before operating
the freezer. When properly operated and
maintained the freezer will produce a
consistent quality product.
2

Note to Installer

This freezer must be installed and
serviced by an Electro Freeze Distributor
or authorized service technician
in accordance with the installation
instructions in this manual.
Verify the weight of the freezer. Ensure
a counter or table of sufficient strength
is used to hold this weight and prevent
excessive vibration.
Air cooled models require a minimum of
3-inches (7.6 cm) air space on both sides
and back of the freezer for adequate
ventilation.
184592-01
ELECTRO FREEZE Shake Model CS705-M2
If you require technical assistance, please
contact your local authorized Electro
Freeze Distributor, as follows:
Name: ________________________
Address: ______________________
Phone: ________________________
For factory service
assistance — contact H.C. Duke & Son,
LLC, Electro Freeze Service Department
as follows.
If this freezer is to be used in a self-
service application, it is recommended
that the machine be fitted with a self-
service kit. Contact your Electro Freeze
Distributor or H. C. Duke & Son, LLC for
this kit.
Test the operation of the head safety
switch prior to placing the freezer
in service. See Section 12, Routine
Maintenance, Monthly.
After installation the warranty registration
card must be completed and returned to
validate the warranty.
 Phone: 309-755-4553
800-755-4545
FAX: 309-755-9858
E-mail: service@hcduke.com
1