Electrical Requirements; Specifications; Particulars - ELECTRO FREEZE COMPACT Series Operator's Manual

2.3

Electrical Requirements

1. Always verify electrical specifications
on the data plate (figure 4-1) of
each individual freezer. Data plate
specifications will always supersede
the information in this manual.
2. This freezer requires a protected 20
amp 230 volt circuit. Connect the
freezer to a circuit separate from any
other electrical equipment. The power
cord on this freezer connects to a
NEMA 6-20R receptacle. See Figure
3-1.
3

Specifications

3.1

Particulars

Width (in/cm)
Height (in/cm)
Depth (in/cm)
Weight (lbs/kg)
Voltage*
Min. Circuit Ampacity
Compressor
Beater Motor
Refrigerant
Charge
Cooling
Hopper
Cylinder
*Contact factory for other voltages.
Noise: The Steady acoustic pressure level, for both air cooled and
water cooled freezers, is less than 70dB(A).
184592-01
ELECTRO FREEZE Shake Model CS705-M2
CAUTION
All materials and connections
must conform to local
requirements and be in
compliance with the National
Electric Code (NEC).
CAUTION
To prevent accidental electrical
shock, a receptacle with
a positive earth ground is
required.
18.4/46.7
58.9/149.7
28.1/71.4
250/113.4
208-230/60/1
1 HP/8000 (BTUH)
.75 kw (Motor)
2.3 kw (Cooling)
1/2 HP/.37 kw
32.0 oz/.91 kg
20 qts/18.8 liters
7 qts/7.1 liters
3. Supply voltage
must be within
±10% of voltage
indicated on
the nameplate.
Request your
local power
company
to correct
any voltage
problem.
4. The control transformer in the
electrical box is factory wired to 208
volts (red) wire tap for 208V nominal
power supply. If power supply is
between 230-240 volts use 240V
(orange) wire tap on transformer.
5. Beater Shaft Rotation - Freezers are
designed for clockwise rotation when
viewed from front of freezer. 1ph
machines are pre-wired for proper
rotation. On 3phase machines,
phase wires to freezer should be
connected to produce proper beater
rotation. This is to be done by a
freezer technician.
20.0
R-404a
Air
Figure 2-1
3