ELECTRO FREEZE COMPACT Series Operator's Manual page 36

ELECTRO FREEZE Shake Model CS705-M2
9 Daily Procedures
9.1 Night or Idle Operation
9.1.1 General Cleaning
1. Remove the spinner flex shaft
cover assembly (1) in preparation to
disassemble the shake mix chamber
(9).
SAFETY NOTE: Removal of the flex shaft
cover disables the spinner motor.
2. Disconnect the syrup lines and water
rinse line from the mix chamber.
3. Remove the mix chamber and set
aside for cleaning.
4. Disconnect the flex-shaft from the
spinner shaft (taking care not to drop
the spinner shaft which will fall out of
the plunger), remove the spinner shaft
from the shake head.
5. Prepare a container of sanitizing
solution. Sanitizing solution must be
mixed according to manufacturer's
instructions to yield 100 PPM strength
chlorine solution. (example: Stera-
Sheen Green Label). Use warm water
(100-110°F or 37-43°C). Fill the wash
bottle with sanitizing solution.
6. Using a brush and bottle of sanitizing
solution wash down the bottom of the
shake head and plunger, being sure
to clean the plunger spinner shaft hole
with a brush.
7. Using the bottle of sanitizing solution.
a. rinse down the head, end of the
plunger, and plunger spinner shaft
hole
c. spray out the ends of each syrup
line connector. Also spray the end of
the connector for the water line.
d. wash the mix chamber using a
brush to clean the center bore as well
as each of the syrup holes.
e. wash the spinner shaft using a
brush to clean the paddle holes.
26
Figure 9-1
f. rinse off the cleaned mix chamber
and spinner shaft with clean sanitizing
solution.
8. Set parts aside to dry.
9. Leave shake mix system dis-
assembled overnight and re-assemble
prior to the next use. See Assembly
Section 7.
10. If your location is open 24 hours,
system must be cleaned once a day,
we recommend cleaning steps 1
through 11 in the morning or other
slow period.
184592-01