ELECTRO FREEZE COMPACT Series Operator's Manual page 46

ELECTRO FREEZE Shake Model CS705-M2
12 Routine Maintenance
MONTHLY
A. Test Head Switch.
The head switch feature is designed
to prevent the beater shaft from being
accidentally activated. It is essential that the
proper operation of this switch be verified on a
routine basis. Use the following instructions to
test for proper operation:
1. Be sure all switches are in the "OFF"
position.
2. Disconnect the main power supply.
3. Remove the dispense head and beater
shaft assembly.
4. Connect the main power supply.
5. Turn the selector switch to the "CLEAN"
position.
Moving parts. Do not place hands
in the freezing cylinder. Severe
personal injury could result.
6. Look inside the freezing cylinder toward
the rear. The drive shaft coupling should
NOT be turning. Turn the selector switch
to "OFF" and disconnect the main power
supply.
7. If the drive shaft coupling is turning, or you
are unable to determine whether or not
the shaft is turning, turn the switch to the
"OFF" position, disconnect the main power
supply, and contact your Electro Freeze
distributor for service. DO NOT place the
freezer in service until the problem has
been fixed.
36
CAUTION
C. Air Condenser.
Call your Electro Freeze Distributor for service to clean air condenser
fins.
— continued
MONTHLY
B. Test Flex Cover Switch.
The flex cover switch feature is designed to
prevent the spinner shaft from being accidentally
activated. It is essential that the proper operation
of this switch be verified on a routine basis.
Use the following instructions to test for proper
operation:
1. Be sure all switches are in the "OFF" position.
2. Disconnect the main power supply.
3. Remove the flex shaft cover.
4. Connect the main power supply.
5. Turn the selector switch to the "CLEAN"
position.
DO NOT touch or get too close to
moving parts. Clothing, jewelry, hair or
other body parts may become caught
in the machine and result in personal
injury.
6. Place a container under the dispensing
plunger.
7. Push the rinse switch button. The spinner
shaft should NOT be turning. Water will be
dispensed. Turn the selector switch to "OFF"
and disconnect the main power supply.
8. If the spinner shaft is turning, or you are
unable to determine whether or not the shaft
is turning, turn the selector switch to the "OFF"
position, disconnect the main power supply,
and contact your Electro Freeze distributor for
service. DO NOT place the freezer in service
until the problem has been fixed.
CAUTION
184592-01