ELECTRO FREEZE COMPACT Series Operator's Manual page 17

4 Part Names and Functions
The following part names and descriptions refer to figure 4-1.
1.) COVER - ASSY FLEX SHAFT:
Protects from accidental contact with
rotating shaft. Must be in place to
operate.
2.) O-RING - HEAD:
Seals the head to the freezing cylinder.
Must be lubricated.
3.) BUSHING - BEATER BEARING:
Holds the beater in place at the front
of the cylinder. Must be inserted
into the head and lubricated
before assembly.
4.) KEEPER - ASSY SPINDLE:
Secures the handle to the head.
5.) HEAD - DISPENSE:
Encloses the freezing cylinder and
provides an opening for product to
be dispensed.
6.) QUICK CONNECT WITH SHUT
OFF:
Allows syrup line to be removed from
the mix chamber.
7.) O-RING - SYRUP LINE:
Prevents syrup from leaking.
8.) SHAFT - ASSY MIX:
Mixes flavor into shake mix.
9.) CHAMBER - MIX:
Delivers syrup to the shake mix.
10.) O-RING - CHAMBER:
Prevents mix from leaking. Lightly
lubricate.
11.) HANDLE - ASSY COMPLETE:
Opens and closes the plunger to start
and stop the flow of product from the
freezer.
12.) O-RING - PIVOT POST:
Holds the pivot post in place. Lightly
lubricate.
13.) POST - PIVOT:
Holds the handle in place.
184592-01
ELECTRO FREEZE Shake Model CS705-M2
14.) PLUNGER - DISPENSING:
Seals the product opening in the head
when closed. Allows product to flow
when open.
15.) BUSHING - MIXER SHAFT:
Holds the mixing shaft in place.
Prevents wear on plunger.
16.) ROD - ACTUATOR:
Starts the freezer when dispensing.
Must be in place before product can
be dispensed.
17.) O-RING - PLUNGER-UPPER
18.) O-RING - PLUNGER-LOWER:
Seals the plunger in the head.
Must be lubricated to seal and slide
properly.
19.) SHAFT - FLEXIBLE W/CASING
16-1/2:
Spins the mix shaft.
20.) CONNECT - ASSY DRIVE:
Quick connector used to connect or
disconnect the flexible shaft from the
mix shaft.
7