ELECTRO FREEZE COMPACT Series Operator's Manual page 12

ELECTRO FREEZE Shake Model CS705-M2
2.1 Uncrating and Inspection
When the unit is received and while
the carrier is still present, inspect the
shipping carton for any damage that
may have occurred in transit. If the
SHOCKWATCH
or the carton is broken, torn, or punctured
note the damage on the carrier's freight
bill and notify the carrier's local agent
immediately. Also note on the freight bill.
2.2 Installation
1. This freezer is designed for indoor use
and must be protected from outdoor
weather conditions.
2. This freezer requires a potable water
connection for the rinse line. The
water inlet is located at the back of
the freezer next to the power supply. A
3/8" MPT water inlet connector will be
needed.
2
CAUTION
Be sure to properly support
the machine when removing
bolts and installing legs or
casters.
label indicates red and/
®
CAUTION
All materials and connections
must conform to local
requirements and be in
compliance with the National
Electrical Code (NEC).
CAUTION
Tip Hazard. Front side of
freezer must remain positioned
on door side of cart. DO NOT
reverse position of freezer on
cart.
1. Remove the carton from the pallet,
and move the machine as close as
possible to the permanent location.
2. Remove the shipping bolts on the
bottom of the freezer and remove the
freezer from the pallet.
CAUTION
Use caution when moving the
freezer to avoid a tip hazard.
3. A minimum 3-inch (7.6 cm) air space
is required on both sides and back of
the freezer for adequate ventilation.
4. Test the operation of the head and
flex shaft cover safety switches prior
to placing the freezer in service. See
Section 12, Routine Maintenance,
Monthly.
184592-01