Assembly - ELECTRO FREEZE SOFT SERVE TWIST SL500 Operator's Manual

7

Assembly

DO NOT
LUBRICATE
SHAFT SEAL
Figure 7-1
Figure 7-2
Figure 7-3
184599
SEAL-BEATER SHAFT
DO NOT
LUBRICATE
SHAFT SEAL
LUBRICATE WASHER
WASHER
Lubricate shaft seal
Assemble beater shaft
assembly
Lubricate bearing areas of
breaker bar
ELECTRO FREEZE Soft Serve Model SL500
Correct assembly of the freezer is essential
to prevent leakage of the product and
damage to the freezer. To assemble the
freezer you will need an approved lubricant,
such as Petrol Gel. Make sure all parts of
the assemblies have been washed and
sanitized before assembling. Follow these
directions for each cylinder of the freezer.
1. Persons assembling the freezer
must first wash and sanitize their hands
and forearms with an approved sani-
tizer.
2. To assemble the shaft seal,
install the cup seals on the plastic
washer. Apply a moderate amount of
approved sanitary lubricant (such as Petrol
Gel) to the washer. Do not allow any
lubricant to come in contact with the bell-
shaped rubber portions of the seal (figure 7-
1).
3. Install the shaft seal over the rear of
the beater shaft, (figure 7-2).
4. Apply lubricant to the bearing areas
of the breaker bar (figure 7-3).
5. Place the scaper blades on the
beater shaft, making sure the blades
are installed properly.
6. Slide the breaker bar into the
center of the beater shaft, making sure
the bar fits into the hole in the rear
beater shaft disc (figure 7-2).
CAUTION
To avoid electrical shock
or contact with moving
parts, make sure all
switches are in the "OFF"
position and that the main
power supply is
disconnected. Some
freezers have more than
one disconnect switch.
— continued
19