ELECTRO FREEZE COMPACT Series Operator's Manual page 45

12 Routine Maintenance
Electro Freeze recommends the following
schedule to help maintain your equipment
in like-new operating condition. Take the
time to learn and perform these routine
procedures and receive in return many
years of valuable service from your
freezer. Protect your investment.
1. Disassemble, wash, rinse, sanitize, air
dry, reassemble and sanitize all parts
that come into contact with the mix or
product.
2. Clean and sanitize syrup lines with
sanitizing solution.
3. Clean the cylinder and drain tube with
the appropriate brushes.
4. Upon cleaning, inspect and lubricate
all seals and O-rings as instructed that
come into contact with mix. Replace
any O-ring that is worn, torn, or loose-
fitting.
5. Wipe all exterior surfaces of the
freezer to remove any splattered mix.
6. Check overrun and temperature of the
product.
184592-01
ELECTRO FREEZE Shake Model CS705-M2
DAILY
CAUTION
To prevent bacteria growth,
remove all O-rings when
cleaning. Failure to do so could
create a health hazard.
WEEKLY
1. Carefully inspect all parts for wear
including, seals, O-rings, mix transfer
tube and blades.
2. Replace as required.
Replace blades if worn 3/16" or more.
3. Check the beater tangs and drive
shaft for wear.
GOOD SHAFT
TANG
A worn coupling will have a nonparallel
shape on the drive opening.
4. Check the air filter and clean as
necessary. After cleaning apply spray
adhesive, p/n HC162548.
35