ELECTRO FREEZE COMPACT Series Operator's Manual page 28

ELECTRO FREEZE Shake Model CS705-M2
6.3 Cleaning Instructions
Figure 6-7 Clean shaft seal and plunger
Figure 6-8 Clean scraper blades
Figure 6-9 Clean hopper and mix feed port
18
— continued
3. After all parts are washed, rinse and
place them in the sanitizing solution.
For proper sanitizing, all parts
must remain fully immersed in the
sanitizer for 5 minutes. Allow parts
to air-dry after sanitizing.
Do not leave parts in sanitizer for more
than 15 minutes.
4. Wash hopper walls and all soiled
surfaces on the freezer with a clean
disposable towel.
5. Using the spray bottle filled with
sanitizing solution spray out the end
of each syrup line and the water line
connector.
6. Using proper brush, brush the hopper
inlet tube (figure 6-9), the drain tube,
the cylinder, and cylinder back wall
(figure 6-10), thoroughly with dish
detergent solution. Rinse using rinse
M00968
bottle. Using sanitizing solution,
repeat brushing procedure making
sure all surfaces contact sanitizer.
Drain Tube
Figure 6-10 Clean drain tube & cylinder
Replace worn brushes. Use only
Electro Freeze original or authorized
replacement parts. See Accessories
Parts List in Part II of this manual to
c. The shaft cup seal, washer,
and plunger O-ring grooves (figure
6-7).
d. The beater shaft and the
scraper blade pin holes, shown in
figure 6-8.
e. The mixer shaft and bushing.
g. Mix chamber and tubes.
Important:
order new brushes.
Cylinder
184592-01