ELECTRO FREEZE COMPACT Series Operator's Manual page 26

ELECTRO FREEZE Shake Model CS705-M2
6.2 Disassembly Instructions
Figure 6-3 Beater Shaft Assembly
11. Remove the beater bearing bushing
(figure 6-2, 3) and beater shaft
(figure 6-3) from the cylinder. Then
remove the scraper blades (2) and
shaft seal (3,4) from the beater shaft
(1). Remove the cup seals (3) from
the washer (4) on the shaft seal
assembly. Remove the drip tray.
12. Remove the mix feed tube assembly
from the hopper, as shown in figure
6-4 and remove the o-rings (2).
13. Remove the float from the hopper.
14. Wipe off all lubricants with paper
towel.
16
— continued
TUBE-MIX FEED
Tube-Mix Feed
O-Ring
O-RING
Figure 6-4 Disassemble Mix Feed Tube
O-RING
O-Ring
INSERT - ASSY.
Insert-Assy. Mix
MIX FEED
Feed
184592-01