Assembly - ELECTRO FREEZE FREEDOM 360 Series Operator's Manual

7

Assembly

Figure 7-1 Shaft Seal Assembly
B L A D E -
S C R A P E R
Figure 7-2 Beater Shaft Assembly
Figure 7-3 Scraper Blade Installation
184621
ELECTRO FREEZE Soft Serve Model 99T-RMT
CUP SEAL
WASHER
O-RING
Correct assembly of the freezer is
essential to prevent leakage of the
product and damage to the freezer. To
assemble the freezer you will need an
approved lubricant (such as Petrol-Gel).
Make sure all parts of the assemblies
have been washed and sanitized before
assembling. Follow these directions for
each cylinder of the freezer.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are
in the "OFF" position and
that the main power supply
is disconnected. Some
freezers have more than
one disconnect switch.
1. Persons assembling the freezer
must first wash and sanitize their hands
and forearms with an approved sani-
tizer.
2. To assemble the shaft seal,
install the cup seal and O-ring on the
bushing (see figure 7-1). Apply a light
amount of approved sanitary lubricant
(such as Petrol-Gel) to the O-ring and
the face of the plastic washer opposite
the bell portion of the seal. Do not allow
any lubricant to come into contact with
the bell-shaped rubber portion of the
seals.
3. Install the shaft seal over the
rear of the beater shaft, with the bell-
shaped portion facing the rear, as
shown in figure 7-2.
4. Place the scraper blades on the
beater shaft, making sure the blades
are installed properly (see figure 7-3).
5. Install the assembled beater
shaft into the cylinder by placing the
rear blade on the bottom of the cylinder.
This will center the beater and allow
alignment with the drive coupling.
Rotate the beater assembly while
pushing, until the shank has engaged
the coupling. Repeat for second cylinder
assembly.
-continued
23