Assembly - ELECTRO FREEZE SLX400E Operator's Manual

9

Assembly

DO NOT
LUBRICATE
SEAL
Figure 9-1 Lubricate shaft seal
BAR -BREAKER
SHAFT - ASSY
BEATER
BLADE - SCRAPER
Figure 9-2 Assemble beater shaft
assembly
Figure 9-3 Lubricate bearing areas of
breaker bar
184584
ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
WASHER
LUBRICATE
HERE
BLADE - SCRAPER
SEAL - BEATER SHAFT
LUBRICATE
Correct assembly of the freezer is
essential to prevent leakage of the
CUP SEAL
product and damage to the freezer. To
DO NOT
assemble the freezer you will need an
LUBRICATE
approved lubricant, such as Petrol Gel.
SEAL
Make sure all parts of the assemblies
have been washed and sanitized before
LUBRICATE
WASHER
assembling. Follow these directions for
each cylinder of the freezer.
1. Persons assembling the freezer must
LUBRICATE
2. To assemble the shaft seal, install the
HERE
WASHER - DOUBLE 3. Apply a moderate amount of approved
SHAFT SEAL
4. Apply lubricant to the bearing areas of
5. Place the scraper blades on the
6. Slide the breaker bar into the center
7. Insert the assembled beater shaft into
LUBRICATE
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure the control pad
is "OFF" and that the power
switch is "OFF".
first wash and sanitize their hands and
forearms with an approved sanitizer.
cup seals on the plastic washer as
shown in figure 9-1.
sanitary lubricant (such as Petrol Gel)
to the beater shaft as shown in figure
9-2. Install the shaft seal over the
rear of the beater shaft, (figure 9-2).
Do not allow any lubricant to come in
contact with the bell-shaped rubber
portions of the shaft seal.
the breaker bar (figure 9-3).
beater shaft, making sure the blades
are installed properly.
of the beater shaft, making sure the
bar fits into the hole in the rear beater
shaft disc (figure 9-2).
the cylinder by placing the rear blade
on the bottom of the cylinder. This
will center the beater shaft and allow
alignment with the drive coupling.
Rotate the beater assembly while
pushing, until the shank has engaged
the coupling. Install both beater
shafts.
— continued
25