JLG X17JPLUS Operator, Safety, And General Maintenance Manual page 92

USING THE MACHINE
c In the case of the electric motor 230V to the network are required at least
3.9Kw. Use to connect a cable pole least ʺ3x2.5mm2ʺ with ground socket type F47,
double insulated with plug for at least 16A. The maximum cable length must be
10 m
d In the case of the electric motor 110V to the network are required at least
4.1Kw. Use to connect a cable pole least ʺ3x6mm2ʺ with ground socket type F47,
double insulated with plug for at least 32A. The maximum cable length must be
10 m
e Place an earth plate in the ground and connect it to the machineʹs ground
clamp or, if this is not possible, make sure the power connection is earthed (e.g.
indoors).
• Make sure that all the emergency STOP buttons are released; this condition
can be checked on the remote control display, where no icon should appear in po‐
sition 7 ʺFig. 40 Emergency stop pressed(p. 56)ʺ. If the operator attempts to start
the machine with the emergency stop button still pressed, an error message will
appear on the display when the start button is pressed.
• Use the button on the remote control to start the motor.
• If the operator attempts to start one of the two motors while the other is alre‐
ady running, starting will be impossible and the icon showing the motor already
on will appear at the centre of the screen.
The engine must be started with all the control buttons and joysticks
in neutral position. Always make sure there are no foreign objects
(e.g. Branches) that may accidentally operate a control, as the pla‐
tform may move suddenly out of the operatorʹs control and cause se‐
rious harm to things and/or people. Make sure that all the manual
controls for the proportional valves are at rest.
90
Fig. 83 Error, ignition attempt with stop pressed
Boom Lift Models X17JPLUS
MUX17JP021602