JLG X17JPLUS Operator, Safety, And General Maintenance Manual page 107

MUX17JP021602
PROCEDURE FOR ROUTINE MOVEMENT OF THE AERIAL PART
a Before moving the aerial part, make sure that:
– All instructions provided in this chapter have been complied with.
– There are no obstacles in the work area.
– All the conditions necessary for working at a height are met.
– The machine is stabilised and levelled: icon 5 shown on the display.
– The weight in the basket is below the maximum allowed.
– The remote control is positioned in the basket.
– The basket access ladder has been folded into the raised position so as not
to risk contact during movement of the aerial part.
b The aerial part can ONLY be moved from the control position in the basket.
c Select the motor speed as required and check the selection on the display.
d Use joysticks on the remote control to move the aerial part as described in the
paragraph regarding the description of the controls ʺJoystick (p. 57)ʺ.
e If the movements are selected when one of the conditions listed above is not
satisfied, an error message will be shown on the display indicating what condi‐
tions are OK and what are not satisfied (FAIL). If the missing condition is stabili‐
sation, the message will also indicate what stabiliser is not resting on the ground.
Fig. 97 Error machine not stabilised
ST1: if OK stabiliser 1 is resting on the
ground
ST2: if OK stabiliser 2 is resting on the
ground
ST3: if OK stabiliser 3 is resting on the
ground
ST4: if OK stabiliser 4 is resting on the
ground
INLC: if OK the machine is under the
maximum inclination limit
LOAD: if OK, the load is less than the
maximum working load allowed
BASKET: if OK the remote control is in
place in the basket
PEDAL: if OK the foot switch is pushed
Boom Lift Models X17JPLUS
USING THE MACHINE
105