Emergency Control Position - JLG X17JPLUS Operator, Safety, And General Maintenance Manual

Table of Contents

INSTRUMENTS AND CONTROLS

tion, the operator uses the same remote control, removing it from its housing in

the basket and using the cable provided.

From this control position, the operator IS NOT enabled to control the aerial

part of the machine, but only the tracks, stabilisers and track extension fun‐

ction.

When controlling the machine from the ground position, keep a di‐

stance of at least 1 m from the tracks.

When controlling the machine from the ground position, always

make sure that the component that is being moved is completely vi‐

sible and constantly check its trajectory.

9.3.3. Emergency control position

There is a control position which will be identified as the emergency control po‐

sition. This is located on the ground part of the machine, next to the distributor

for the aerial part. To enable it, press the special selector positioned on the base

of the turret until the green warning light comes on. The light indicates that the

movements of the aerial part are enabled.

Fig. 55 Selector Petrol/Diesel version

From this position, the movements of the machine can be controlled directly

using the levers on the various hydraulic distributors, aerial part and proportio‐

nal.

Boom Lift Models X17JPLUS

MUX17JP021602

Fig. 56 Selector Lithium version

Table of Contents