Table of Contents
Advertisement
MUX17JP021602
The automatic procedure for levelling the machine extends and re‐
tracts the stabilisers, and consequently moves the machine. Always
check that there are no people, animals or things in the stabilisation
area.
AUTOMATIC LOWERING OF THE STABILISERS
Press and hold button 7 on the remote control.
The success of the self‐levelling procedure is confirmed by an icon displayed on
the screen for several seconds.
If the self‐stabilization procedure has not been completed and the OK message
has not appeared on the display it will not be possible to move the aerial part of
the machine and at every attempt to do it an error message will appear: AUTO‐
STAB NO. Repeat the Self‐stabilization operation to enable movements.
After the end of the procedure, always control that the spirit level is in the gre‐
en zone. If this does not occur contact the after sales service.
If during lowering one of the stabilisers does not touch the ground, the machine
will continue to operate the cylinder at the end of its stroke until the motor swi‐
tches off or the self‐levelling procedure ends. This situation is normal and indica‐
tes that the slope the machine is situated on exceeds the allowable limit for
Fig. 93 Auto‐Stabilization completed successfully
Boom Lift Models X17JPLUS
USING THE MACHINE
101
Advertisement
Table of Contents
