Remote Control Move (Optional) - JLG X17JPLUS Operator, Safety, And General Maintenance Manual

MUX17JP021602
9.4. REMOTE CONTROL MOVE (OPTIONAL)
In order to enable the ground movements of the machine is compulsory push the
8 button. If the 8 button is not pressed before move the ground part a message
appear on the remote control display. Once pressed the 8 key if are not move
commands within 7 seconds consents will be disabled and will be need to press
the button 8 again to reactivate them.
This option is enabled as standard for the Australian market machine.
9.5. SKYGUARD
TM
The SkyGuard
When the SkyGuard
of actuation will reverse or cut‐out and the ground alarm will beep. The table be‐
low outlines these functions.
Reverse motion can be stopped by the operator by releasing the footswitch, depres‐
sing the emergency stop button, or by releasing pressure on the SkyGuard
sor.
TM
If SkyGuard remains activated after function reversal or cutout, depress and
hold the SkyGuard
machine functions until the SkyGuard
1 boom 3 boom
up up
R R
R= Indicates Reversal is Activated
C= Indicates Cutout is Activated
TM
SYSTEM (OPTIONAL)
feature is used to provide enhanced control panel protection.
TM
sensor is activated, functions that were in use at the time
TM
Override Switch (button number 8) to allow normal use of
JIB up Exten‐
sion
out
C R
Boom Lift Models X17JPLUS
INSTRUMENTS AND CONTROLS
TM
sensor is disengaged.
Rota‐ Rota‐
tion tion
AE Basket
R C
Basket Drive
level‐ Forwar
ling d
C C
TM
sen‐
Drive
Rever‐
se
C
67