Emergency Position Controls; Selection Panel, Emergency Stop And Starting - JLG X17JPLUS Operator, Safety, And General Maintenance Manual

EMERGENCY DEVICE
Considering the hazard deriving from the use of the platform during
the bypass of the safety devices, carefully read the paragraphs regar‐
ding the use of the safety device release key selector switch.
The key used to activate the safety device bypass is lead sealed on the side of the
electrical components compartment near the battery. Force the lead sealing to re‐
move it. After using the safety device bypass an after sales centre must be con‐
tacted in order to verify the causes that determined the need to use the safety
device bypass and to lead seal the key.
The safety device bypass system is used to move the machine with a
higher load than the limit load allowed inside the basket; the overlo‐
ad alarm is nonetheless displayed and the beeper warns the operator
of the dangerous conditions. This device must only be used by expert
personnel trained on how to use the machine, while the end user, who
does not fully know the machineʹs operating principles, is not al‐
lowed to use this device.
The safety device electronic control board records when the safety device bypass
key is used and the movements carried out during these operations.
10.5.EMERGENCY POSITION CONTROLS
10.5.1.Selection panel, emergency stop and starting
Fig. 67 Selector Petrol/Diesel version
72 Boom Lift Models X17JPLUS
MUX17JP021602
Fig. 68 Selector Lithium version