Table of Contents
Advertisement
USING THE MACHINE
It is important to remind that when the stabilisers are lowered the
carriage must always be raised from the ground.
After using the manual stabiliser control, remember to pressurise the
bottom of the stabiliser cylinders. To do this, run an auto‐stabilisa‐
tion cycle or lower each stabiliser for one second.
Incorrect machine stabilisation does not ensure suitable stability to
perform operations. The Constructor prohibits the use of the machine
if it is not stabilised as described in this manual; the machine over‐
turning may cause serious injury to or even death of its occupants
and personnel on the ground.
If one of the orange lights positioned on each stabiliser should flash even
when the stabiliser is lifted from the ground, stop the machine immediately
and call the after‐sales service as this signals the breakage of the correspon‐
ding stabiliser micro switch.
If working with the machine stabilised on slippery surfaces (marble,
porphyry, polished cement, smooth damp surfaces etc.) check that the
movements of the basket do not cause the tracks to move. If so, stop
the operations and restore the safe operating conditions prescribed
by the manufacturer.
Make sure that the stabilisers rest on horizontal ground.
DO NOT REST THE STABILISERS ON VERTICAL OR INCLINED
SURFACES.]
11.4.10.Automatic lowering and raising of the stabilisers
The elevating platform is fitted with an innovative automatic levelling procedure
that acts on the stabilisers and uses the electronic spirit level provided on the
main control board. For the self‐levelling procedure, all the precautions described
to this point apply. Before starting the self‐stabilization make sure that the machi‐
ne is on a slope less than the total permitted limit for stabilization ʺTechnical data
(p. 19)ʺ and verify that the trajectory of the stabilizers is free of obstacles and im‐
pediments.
100
Boom Lift Models X17JPLUS
MUX17JP021602
Advertisement
Table of Contents
