Connections And Terminal Designations; Basic Devices - Siemens SITOP PSU8600 Manual

Description, device design, dimension drawing

2.6 Connections and terminal designations

2.6 Connections and terminal designations
2.6.1

Basic devices

The line input terminals
output terminals
to other supplementary modules can be established using the 0 Volt terminal
The operating state of the device can be interrogated using signaling contact
terminal
Ethernet/PROFINET cables (RJ45 plug connection 8P8C) are connected at the
Ethernet/PROFINET interface
Connections and terminal designations
①
②
③
④
Remote reset RST
⑤
See the diagram in Section "Description of the basic devices (Page 17)".
Terminal data 6EP3436-8SB00-2AY0:
*1) Do not subject the end stop to high loads
*2) Derating 18 A/60 °C or 20 A/50 °C
32
①
②
and the 0 V terminal
④
is used for a remote reset of the electronic overload shutdown.
Line input L1, L2, L3, PE
Output 1
0 Volt terminal 0 V
Signaling contact 11, 12, 14
PROFINET (2-port switch)
can be used to establish the connection to supply voltage. The
③
are the load connections. A ground connection
⑤
for PROFINET operation.
Plug-in terminal each with a screw connection
Plug-in terminal with two screw connections
Plug-in terminal with three screw connections
Common plug-in terminal with a screw connection
RJ45 8P8C plug connection
③
.
④
. The reset
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76