Connections And Terminal Designation - Siemens SITOP Series Operating Instructions Manual

Description, device design, dimension drawing

2.2 Connections and terminal designation

2.2 Connections and terminal designation
The line input terminals
The output terminals
Installation (Page 27)).
Connections and terminal designations
①
②
②
⑤
⑤
*1)
Figure 2-2
10
①
②
are used to connect to the loads to be supplied (see also section
Line input L1, N, PE
Output +
Output –
Signaling contact 13, 14
Remote contact 15, 16
Do not subject the end stop to higher loads
Terminal data
can be used to establish the connection to the supply voltage.
One screw terminal each
Two screw terminals
Two screw terminals
One screw terminal each
One screw terminal each
Operating Instructions, 06.2014, C98130-A7633-A1-2-7629
SITOP PSU8200 1ph