Connections And Terminal Designation - Siemens SITOP SEL1200 Manual

2.2

Connections and terminal designation

The input terminals
"0 V" connection
used to connect to the loads to be supplied (see also Chapter Installation (Page 33)).
The operating state of the device can be processed using the group signal contact
the function and content rating, see Figure 2-4 Status displays and signaling (Page 13)).
The remote reset (RST) input
down (function, see Chapter Status displays and signaling (Page 13)).
Connections and terminal designations
①
②
③
④
remote reset (RST)
*1)
Figure 2-2
NOTICE
Overload of the wiring
The "0 V" connection is only used to supply the internal electronics of the selectivity
module. The 0 V of the connected loads must be routed directly to the power supply using
separate cables!
SITOP SEL1200-1400
Manual, 06.2019, A5E46496083-1-76
①
can be used to establish the connection to the supply voltage. The
②
is used to supply the internal electronics. The output terminals
24 V DC input
0 V connection for the internal supply
24 V DC output: 1 - 8
Group signaling contact (13, 14); not assigned (NF);
Do not subject the end stop to higher loads
Terminal data
Description, device design, dimension drawing
2.2 Connections and terminal designation
④
is used to reset outputs that have automatically been shut
2 spring-loaded terminals
2 spring-loaded terminals
one spring-loaded terminal each
one spring-loaded terminal each
③
are
④
(for
11