Operator Controls; Basic Units - Siemens SITOP PSU8600 Manual

2.7

Operator controls

2.7.1

Basic units

There are two main operating areas at the SITOP PSU8600 basic unit.
● LED buttons
The potentiometers are used to set the output voltage and response threshold value of
the output current. The output is switched-on and switched-off using the button. The
button can be used to make a manual reset after an electronic overload shutdown.
● Special functions can be activated using the position of the DIP switches (
the magnifying glass in the diagram).
No.
①
②
③
④
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
①
and potentiometers (
Designation Function
Labeling
LED button Switches on and switches off the output, or resets the output
"ON/OFF/RST" after an electronic shutdown; see Chapter "Switching an output
on and off (Page 84)" and "Overload shutdown and carrying out
a reset (Page 85)".
Voltage Sets the voltage of the relevant output; see Chapter "Setting the
potentiometer "U (V)" output voltage (Page 83)".
Current Sets the response threshold of the output current; see Chapter
potentiometer "I (A)" "Setting the response threshold value of the output current
(Page 83)".
DIP switch "REN" Switches over between the MANUAL mode – with setting and
operation at the device – and REMOTE mode with remote con-
trol via PROFINET; see Chapter "MANUAL and REMOTE
operating modes (Page 88)".
Description, device design, dimension drawing
② ③
and ):
2.7 Operator controls
④ ⑪
to , see
39