Driver Mirror Horizontal Sensor Out Of Range High - Chrysler Concorde 2004 Service Manual

MEMORY SEAT
Symptom:

DRIVER MIRROR HORIZONTAL SENSOR OUT OF RANGE HIGH

When Monitored and Set Condition:
DRIVER MIRROR HORIZONTAL SENSOR OUT OF RANGE HIGH
When Monitored: Ignition on.
Set Condition: This code is set when the mirror sensor feedback to the MHSMM is
greater than the mirror out of range high value stored in EEPROM.
DRIVER MIRROR HORIZONTAL POSITION SIGNAL WIRE SHORT TO VOLTAGE
DRIVER MEMORY MIRROR
MEMORY HEATED SEAT MIRROR MODULE
TEST
1 Disconnect the Memory Heated Seat Mirror Module C1 connector.
Turn the ignition on.
Measure the voltage of the Driver Mirror Horizontal Position Signal circuit.
Is the voltage above 4.5 volts?
Yes → Go To 2
→ Replace the Memory Heated Seat Mirror Module.
No
2 Disconnect the Memory Heated Seat Mirror Module C1 connector.
Disconnect the Driver Power Mirror connector.
Turn the ignition on.
Measure the voltage of the Driver Horizontal Position Signal circuit in the driver
power mirror harness side connector.
Is there any voltage present?
Yes → Repair the Driver Mirror Horizontal Position Signal wire for a
→ Go To 3
No
3 If there are no possible causes remaining, view repair.
Repair
POSSIBLE CAUSES
ACTION
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
short to voltage.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Replace the Driver Memory Mirror.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
406
APPLICABILITY
All
All
All