Chrysler Concorde 2004 Service Manual page 774

DRIVEABILITY - NGC
P0171-FUEL SYSTEM 1/1 LEAN —
TEST
12 Turn the ignition off.
Warning: The fuel system is under a constant pressure (even with the engine
off). Before testing or servicing any fuel system hose, fitting or line, the fuel
system pressure must be released.
Raise vehicle on hoist, and disconnect the fuel pressure line at the fuel pump module.
Install special 5/16 fuel line adapter tool #6539 between the disconnected fuel line
and the fuel pump module.
Attach a fuel pressure test gauge to the T fitting on the tool #6539
Turn the ignition on.
With the DRBIII , actuate the ASD Fuel System test and observe the fuel pressure
gauge.
NOTE: Fuel pressure specification is 400 KPa +/- 34 KPa (58 psi +/- 5 psi).
Is the fuel pressure within specification?
Yes → Repair or replace fuel supply line as necessary.
→ Go To 13
No
Caution: Stop All Actuations.
13 Turn the ignition off.
Warning: The fuel system is under a constant pressure (even with the engine
off). Before testing or servicing any fuel system hose,fitting or line, the fuel
system pressure must be released.
Remove the Fuel Pump Module and inspect the Fuel Inlet Strainer.
Is the Fuel Inlet Strainer plugged?
Yes → Replace the Fuel Pump Inlet Strainer.
→ Go To 14
No
14 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Replace the Fuel Pump Module.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Continued
116
APPLICABILITY
All
All
All