Chrysler Concorde 2004 Service Manual page 570

WINDSHIELD WIPER & WASHER
*WIPER, NOT WORKING IN THE HIGH SPEED —
TEST
9 Turn the ignition off.
Remove the Wiper High/Low Relay.
Disconnect the Wiper Motor harness connector.
Measure the resistance between ground and the Wiper High Speed Output circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the High Speed Output circuit shorted to ground.
→ Go To 10
No
10 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Replace the Wiper Motor.
Perform BODY VERIFICATION TEST - VER 1.
Continued
554
APPLICABILITY
All
All