Chrysler Concorde 2004 Service Manual page 368

INSTRUMENT CLUSTER
NO MESSAGES FROM ABS —
TEST
1 With the DRBIII , attempt to communicate with the module that corresponds to the
DTC that is set.
Was the DRBIII able to I/D or communicate with the Module in question?
Yes → Go To 2
→ Refer to Communication category for the related symptom(s).
No
2 NOTE: If this is an active DTC, answer yes to the question.
With the DRBIII , erase DTCs.
Cycle the ignition, wait approximately 1 minute.
With the DRBIII , read DTCs.
Did the DTC reset?
Yes → Replace the Instrument Cluster in accordance with the Service
→ The condition is not present at this time. Monitor DRBIII
No
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Information.
Perform BODY VERIFICATION TEST - VER 1.
parameters while wiggling the related wire harness. Refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1.
352
APPLICABILITY
All
All