Chrysler Concorde 2004 Service Manual page 495

DRIVER DOOR CENTRAL LOCK (ARM)/UNLOCK (DISARM) SWITCH
FAILURE —
Continued
TEST
4 Turn the ignition off.
Disconnect the Driver Cylinder Lock Switch harness connector.
Disconnect the BCM C4 harness connector.
Turn the ignition on.
Measure the voltage of the Driver Cylinder Lock Switch Mux circuit.
Is there any voltage present?
Yes → Repair the Driver Cylinder Lock Switch Mux circuit for a short to
→ Go To 5
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
voltage.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
479
APPLICABILITY
All
All