Chrysler Concorde 2004 Service Manual page 193

Hide thumbs Also See for Concorde 2004:
Table of Contents

Advertisement

*PCI BUS COMMUNICATION FAILURE —
TEST
3
Turn the ignition off.
Disconnect the BCM C1 harness connector.
Disconnect the DRB from the Data Link Connector (DLC).
Measure the resistance of the PCI Bus circuit between the Data Link Connector
(DLC) and the BCM C1 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 4
No
4
NOTE: Reconnect the BCM C1 harness connector.
Turn the ignition on.
Measure the voltage of the PCI Bus circuit at the Data Link Connector (DLC).
Is the voltage above 7.0 volts?
Yes → Go To 5
No
5
Note: Determine which modules this vehicle is equipped with before begin-
ning.
Turn the ignition off.
Disconnect the BCM harness connectors and remove the Body Control Module from
the Junction Block.
Turn the ignition on.
Measure the voltage of each PCI Bus circuit at the BCM C1, C3, C4 connectors and
at the Junction Block Body Control Module connector cavity 10.
Is the voltage steadily above 7.0 volts for any measurement?
Yes → Go To 6
No
6
Turn the ignition off.
Disconnect the module that corresponds to the PCI Bus circuit that measured
steadily above 7.0 volts.
Turn the ignition on.
NOTE: If the PCI Bus circuit for the Memory Heated Seat/Mirror Module
was above 7.0 volts and is equipped with side airbags, disconnect each
module one at a time.
NOTE: If the PCI Bus circuit for the Radio was above 7.0 volts and is
equipped with CD Changer, disconnect the CD Changer before the Radio.
Measure the voltage of the PCI Bus circuit that previously measured above 7.0 volts.
Is the voltage steadily above 7.0 volts with the module disconnected?
Yes → Repair the PCI Bus circuit that measured over 7.0 volts for a
No
ACTION
→ Repair the PCI Bus circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
→ Go To 7
→ Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
short to voltage.
Perform BODY VERIFICATION TEST - VER 1.
→ Replace the module that caused the short to voltage on the PCI
Bus circuit.
Perform BODY VERIFICATION TEST - VER 1.
Continued
177
COMMUNICATION
APPLICABILITY
All
All
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

300m 2004Intrepid 2004

Table of Contents