Chrysler Concorde 2004 Service Manual page 162

COMMUNICATION
*NO RESPONSE FROM BODY CONTROL MODULE —
TEST
4 Turn the ignition off.
Reconnect the Junction Block C2 harness connector.
Remove the Body Control Module from the Junction Block.
Using a 12-volt test light connected to 12-volts, probe the ground circuit (in Junction
Block Body Control Module connector cavity 1).
Is the test light illuminated?
Yes → Go To 5
→ Replace the Junction Block in accordance with the service infor-
No
5 Turn the ignition off.
Reconnect the Junction Block C3 harness connector.
Remove the Body Control Module from the Junction Block.
Using a 12-volt test light connected to 12-volts, probe the ground circuit (in Junction
Block Body Control Module connector cavity 20).
Is the test light illuminated?
Yes → Go To 6
→ Replace the Junction Block in accordance with the service infor-
No
6 If there are no possible causes remaining, view repair.
Repair
ACTION
mation.
Perform BODY VERIFICATION TEST - VER 1.
mation.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
146
Continued
APPLICABILITY
All
All
All