Chrysler Concorde 2004 Service Manual page 468

MEMORY SEAT
RECLINER SENSOR OUT OF RANGE LOW —
TEST
3 Disconnect the Recliner Position Sensor connector.
Disconnect the Memory Heated Seat Mirror Module C2 connector.
Turn ignition off.
Measure the resistance of the Seat Sensor 5 Volt Supply circuit between the Sensor
connector and the Module connector.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the open Seat Sensor 5 Volt Supply circuit.
No
4 If there are no possible causes remaining, view repair.
Repair
5 Turn ignition off.
Disconnect the Memory Heated Seat Mirror Module C1 connector.
Disconnect the Driver Power Seat Recliner Sensor connector.
Measure the resistance of the Recliner Position Signal circuit to ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the Recliner Position Signal circuit for a short to ground.
→ Go To 6
No
6 Turn ignition off.
Disconnect the Memory Seat Module C1 connector.
Disconnect the Recliner Position Sensor connector.
Measure the resistance of the Recliner Position Signal circuit between the Sensor
connector and the Module connector.
Is the resistance below 5.0 ohms?
Yes → Go To 7
→ Repair the open Recliner Position Signal circuit.
No
7 Turn ignition off.
Disconnect the Driver Power Seat Recliner Sensor connector.
Connect a jumper wire between Seat Sensor 5 Volt Supply and Recliner Position
Signal circuits.
Ensure the Memory Seat Module is fully connected before proceeding.
With the DRBIII select: Body Memory Seat Sensors
Turn ignition on.
Read the Recliner Position Sensor voltage
Is the voltage above 4.5 volts?
Yes → Replace the Seat Track Assembly.
→ Go To 8
No
ACTION
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Replace the Memory Heated Seat Mirror Module.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Continued
452
APPLICABILITY
All
All
All
All
All