Chrysler Concorde 2004 Service Manual page 934

DRIVEABILITY - NGC
Symptom:
P1686-NO SKIM BUS MESSAGES
When Monitored and Set Condition:
P1686-NO SKIM BUS MESSAGES
When Monitored: Ignition on or Engine Running.
Set Condition: No BUS messages are received from the SKIM for 20 seconds.
INTERMITTENT CONDITION
PCI BUS CIRCUIT OPEN FROM PCM TO SKIM
LOSS OF SKIM COMMUNICATION
SKIM/PCM
TEST
1 Turn the ignition on.
With the DRBIII , read the DTCs and record the related Freeze Frame data.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Go To 5
No
2 Turn the ignition on.
With the DRB III, attempt to communicate with the SKIM.
NOTE: This test will indicate if the Bus is operational from the DLC to the
SKIM.
Was the DRB III able to communicate with the SKIM?
Yes → Go To 3
→ Refer to symptom BUS +/- SIGNAL OPEN FROM SKIM in the
No
3 Turn the ignition off.
Disconnect the PCM harness connectors.
Disconnect the SKIM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the PCI Bus circuit from the SKIM harness connector to
the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the PCI Bus circuit between the PCM and the SKIM for an
No
POSSIBLE CAUSES
ACTION
COMMUNICATION category.
Perform SKIS VERIFICATION.
open.
Perform SKIS VERIFICATION.
276
APPLICABILITY
All
All
All