Chrysler Concorde 2004 Service Manual page 685

Symptom:
P0016-CRANKSHAFT/CAMSHAFT TIMING MISALIGNMENT
When Monitored and Set Condition:
P0016-CRANKSHAFT/CAMSHAFT TIMING MISALIGNMENT
When Monitored: Engine cranking and Engine running
Set Condition: Powertrain Control Module detects an error when the camshaft position is
out of phase with the crankshaft position.
INTERMITTENT CONDITION
CHECKING INTERMITTENT CMP SIGNAL WITH LAB
CMP WIRE HARNESS INSPECTION
TONE WHEEL/PULSE RING INSPECTION
CKP WIRE HARNESS INSPECTION
TONE WHEEL/PULSE RING INSPECTION
INTERMITTENT CKP SIGNAL
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
TEST
1 WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
Ignition on, engine not running.
With the DRBIII , read DTCs and record the related Freeze Frame data.
With the DRBIII , erase DTCs.
Start the engine and run until operating temp is reached. (Closed Loop)
If the DTC does not reset it may be necessary to take the vehicle on a test drive.
Does the DTC reset?
Yes → Go To 2
No
POSSIBLE CAUSES
ACTION
→ Refer to the INTERMITTENT CONDITION symptom in the
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
27
APPLICABILITY
All