Brake Warning Indicator Inoperative - Chrysler Concorde 2004 Service Manual

INSTRUMENT CLUSTER
Symptom:

*BRAKE WARNING INDICATOR INOPERATIVE

PARK BRAKE SWITCH
RED BRAKE WARNING INDICATOR DRIVER CIRCUIT OPEN - PARK BRAKE SWITCH TO
J/BLOCK
RED BRAKE WARNING INDICATOR DRIVER CIRCUIT OPEN - MIC TO J/BLOCK
BRAKE FLUID LEVEL SWITCH
BRAKE FLUID LEVEL SWITCH GROUND CIRCUIT OPEN
RED BRAKE WARNING INDICATOR CIRCUIT OPEN - BRAKE FLUID LEVEL SWITCH TO
J/BLOCK
INTERMITTENT CONDITION
JUNCTION BLOCK
INSTRUMENT CLUSTER
TEST
1 Turn the ignition on and observe the BRAKE indicator during the bulb check.
Did the BRAKE indicator illuminate during the bulb check?
Yes → Go To 2
→ Replace the Instrument Cluster in accordance with the Service
No
2 NOTE: Diagnose and repair any MIC, ABS, or Communication DTC's before
proceeding with this test.
Is the Brake Warning Indicator only inoperative while using the Park Brake?
Yes → Go To 3
→ Go To 5
No
3 Disconnect the Park Brake Switch harness connector.
Connect a jumper wire between the Red Brake Warning Indicator Driver circuit and
ground.
Turn the ignition on.
Observe the BRAKE indicator.
Did the BRAKE indicator illuminate?
Yes → Replace the Park Brake Switch in accordance with the Service
→ Go To 4
No
POSSIBLE CAUSES
ACTION
Information.
Perform BODY VERIFICATION TEST - VER 1.
Information.
Perform BODY VERIFICATION TEST - VER 1.
356
APPLICABILITY
All
All
All