Chrysler Concorde 2004 Service Manual page 559

*WIPER, NOT WORKING IN THE LOW SPEED —
TEST
4 Turn the ignition off.
Remove the Wiper High/Low Relay from the PDC.
Disconnect the BCM C3 harness connector.
Measure the resistance between ground and the Wiper High/Low Relay Control
circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the Wiper High/Low Relay Control circuit shorted to
→ Go To 5
No
5 If there are no possible causes, view repair
Repair
6 Remove the Wiper High/Low Relay from the PDC.
Using a 12-volt test light connected to ground, probe the Fused B(+) circuit.
Does the test light illuminate?
Yes → Go To 7
→ Repair the Fused B(+) circuit for an open.
No
7 Turn the ignition off.
Remove the Wiper High/Low Relay from the PDC.
Disconnect the Wiper Motor harness connector.
Measure the resistance of the Low Speed Output circuit between the wiper motor and
the PDC High/Low Relay connector.
Is the resistance below 5.0 ohms?
Yes → Go To 8
→ Repair the Low Speed Output circuit for an open.
No
8 If there are no possible causes, view repair
Repair
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Wiper Motor.
Perform BODY VERIFICATION TEST - VER 1.
WINDSHIELD WIPER & WASHER
Continued
543
APPLICABILITY
All
All
All
All
All