Chrysler Concorde 2004 Service Manual page 950

DRIVEABILITY - NGC
P2503-CHARGING SYSTEM VOLTAGE LOW —
TEST
6 Turn the ignition off.
Disconnect the Generator Field harness connector.
Disconnect the PCM harness connector.
Measure the voltage on the (K20) Gen Field Control circuit at the Generator Field
harness connector.
Is the voltage above 1.0 volt?
Yes → Repair the short to voltage in the (K20) Gen Field Control circuit.
→ Go To 7
No
7 Turn the ignition on.
Disconnect the Generator Field harness connector.
Disconnect the PCM harness connector.
Measure the resistance between ground and the (K20) Gen Field Control circuit in
the Generator Field harness connector.
Is the resistance below 100 ohms?
Yes → Repair the (K20) Gen Field Control circuit for a short to ground.
→ Go To 8
No
8 Turn the ignition off.
Disconnect the Generator Field harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K20) Gen Field Control circuit from the Generator
Field harness connector to the appropriate terminal of the special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Go To 9
→ Repair the open in the (K20) Generator Field Control circuit.
No
9 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 3 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 3 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 3 - NGC.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 3 - NGC.
Continued
292
APPLICABILITY
All
All
All
All