Chrysler Concorde 2004 Service Manual page 226

ELECTRICALLY HEATED SYSTEMS
PASSENGER THERMISTOR OUT OF RANGE HIGH —
TEST
3 If there are no possible causes remaining, view repair.
Repair
4 NOTE: Raise the seat to the highest position to gain access to the connectors. The
MHSMM is located at the front of the drivers seat and the Seat Heater connectors are
at the rear of each seat.
Disconnect the Passenger Heated Seat Cushion 4-way connector.
Disconnect the Memory Heated Seat Mirror Module C1 connector.
Turn ignition on.
Measure the voltage between Passenger Seat Temperature Sensor Input circuit, in
the harness side connector and body ground.
Is there any voltage on the Driver Seat Temperature Sensor Input circuit?
Yes → Repair the Passenger Seat Temperature Sensor Input circuit for a
→ Go To 5
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
Replace the Memory Heated Seat Mirror Module
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
short to voltage.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
Replace the Passenger Seat Cushion.
Perform MEMORY HEATED SYSTEM VERIFICATION TEST -
VER 1.
210
Continued
APPLICABILITY
All
All
All