Table of Contents
Advertisement
JR
LICENSE PLATE LAMP UNIT
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove screws attaching license plate lamp
(Fig. 25).
(3) Remove license plate lamp from fascia.
(4) Remove socket from lamp.
Fig. 25 License Plate Lamp
1 - LICENSE PLATE LAMP
INSTALLATION
(1) Install socket to lamp.
(2) Install license plate lamp to fascia.
(3) Install screws attaching license plate lamp.
(4) Connect the battery negative cable.
LICENSE PLATE LAMP UNIT -
JR27 ONLY
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Using a flat bladed tool, gently pry the lamp
from the license plate opening.
(3) Disconnect the wire harness connector.
(4) Remove bulb.
INSTALLATION
(1) Install bulb.
(2) Connect the wire harness connector.
(3) Press lamp into position.
(4) Connect the battery negative cable.
LAMPS/LIGHTING - EXTERIOR
MULTI-FUNCTION SWITCH
DESCRIPTION
The multi-function switch (Fig. 26) contains:
• Turn signals
• Hazard warning
• Headlamps
• Headlamp beam select
• Parking lamps
• Panel dimmer
• Fog Lamp
• Headlamp optical horn
• Windshield wiper
• Pulse wipe
• Mist wipe
• Windshield washer switches.
The multi-function switch is mounted center of the
steering column. There are two levers, one on each
side of the steering column.
OPERATION
The left side controls the signaling and lighting.
The right side controls the windshield wiper and
washer system. When the driver wishes to signal his
intentions to change direction of travel, he moves the
left lever upward to cause the right signals to flash
and downward to cause the left signals to flash. After
completion of a turn the system is deactivated auto-
matically. As the steering wheel returns to the
straight ahead position the turn signals are canceled.
A canceling cam is molded to the clock spring mech-
anism which comes in contact with the cancel actua-
tor on the multi-function switch. The canceling cam
lobe pushes on the cancel actuator and returns the
switch to the off position.
If only momentary signaling such as indication of a
lane change is desired, the switch is actuated to a
left or right intermediate detent position. In this
position the signal lamps flash as described above,
but the switch returns to the OFF position as soon as
the lever is released.
When the system is activated, one of two indicator
lamps mounted in the instrument cluster flashes in
unison with the turn signal lamps, indicating to the
driver that the system is operating. The windshield
wiper and wash system is covered in Wipers/Wash-
ers.
8L - 21
Advertisement
Table of Contents
