License Plate Lamp Bulb – Rear Bumper Fascia; License Plate Lamp Bulb - Chrysler 2000 LHS Owner's Manual

LH
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Push bulb into socket.
(2) Install socket(s) in tail lamp.
(3) Place tail lamp in position on rear closure
panel.
(4) Install nuts attaching tail lamp to rear closure
panel.
(5) Install trunk lining.
(6) Verify lamp operation.
Fig. 13 Tail, Stop, Back up, and Turn Signal Lamp
Bulb – Concorde/LHS
1 – SOCKET
2 – BULB
Fig. 14 Tail, Stop, Back up, and Turn Signal Lamp
Bulb – Intrepid
1 – BODY WIRE HARNESS CONNECTOR
LICENSE PLATE LAMP BULB – REAR BUMPER
FASCIA
REMOVAL
(1) Remove screws attaching license plate lamp to
rear bumper fascia.
(2) Remove license plate lamp from rear bumper
fascia.
(3) Remove socket from lamp (Fig. 16).
Fig. 15 Tail, Stop, Back up, and Turn Signal Lamp
Bulb – 300M
(4) Pull bulb from socket.
Fig. 16 License Plate Lamp Bulb
1 – LICENSE PLATE LAMP
2 – TRUNK LID
3 – SOCKET
4 – BULB
INSTALLATION
(1) Push bulb into socket.
(2) Install socket into lamp.
(3) Place license plate lamp in position on rear
bumper fascia.
(4) Install screws to attach license plate lamp to
rear bumper fascia.
LAMPS 8L - 17