JR
POWER MIRROR SWITCH
DIAGNOSIS AND TESTING - POWER MIRROR
SWITCH
(1) Remove power mirror switch (Refer to 8 -
ELECTRICAL/POWER MIRRORS/POWER MIRROR
SWITCH - REMOVAL).
(2) Disconnect wiring harness connector from
switch.
(3) Using a ohmmeter, test for continuity between
the terminals of the switch (Fig. 2).
(4) If results shown in the table are not obtained,
replace the switch.
Fig. 2 POWER MIRROR SWITCH
POWER MIRROR SWITCH TEST
SWITCH POSITION
MIRROR SELECT SWITCH IN LEFT POSITION
UP
DOWN
LEFT
RIGHT
CONTINUITY BETWEEN
3 AND 1
9 AND 7
7 AND 4
7 AND 1
9 AND 3
4 AND 3
3 AND 1
7 AND 2
8 AND 7
7 AND 1
3 AND 2
8 AND 3
SWITCH POSITION
MIRROR SELECT SWITCH IN RIGHT POSITION
UP
DOWN
LEFT
RIGHT
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick, pry the trim bezel from the
instrument panel.
(3) Disconnect wire harness connector from switch.
(4) Remove switch from bezel.
INSTALLATION
(1) Install switch to trim bezel.
(2) Connect wire harness connector to switch.
(3) Install trim bezel to instrument panel.
(4) Connect battery negative cable.
SIDEVIEW MIRROR
REMOVAL
For service procedures, (Refer to 23 - BODY/EXTE-
RIOR/SIDE VIEW MIRROR - REMOVAL).
POWER MIRRORS
CONTINUITY BETWEEN
10 AND 3
9 AND 7
7 AND 4
10 AND 7
9 AND3
4 AND 3
10AND 3
7 AND 2
8 AND 7
10 AND 7
3 AND 2
8 AND 3
8N - 9