Pivot Ball Position; Release Bearing-To-Lever; Release Bearing And Lever - Chrysler Sebring 2004 Service Manual

6 - 14 CLUTCH
CLUTCH RELEASE BEARING AND LEVER (Continued)
Fig. 21 Pivot Ball Removal/Installation
1 - C-3752 SLIDE HAMMER
2 - REMOVER/INSTALLER 6891
3 - PIVOT BALL
Fig. 22 Pivot Ball Position
1 - PIVOT BALL (1)
(4) Install clutch release bearing/lever assembly
into position by sliding bearing onto input bearing
retainer, and using moderate hand pressure to seat
release lever to pivot ball (Fig. 24). A "pop" sound
should be heard. Verify proper engagement by lightly
pulling outward on lever at pivot ball location, and
then actuating lever and bearing to ensure proper
operation.
Fig. 23 Release Bearing-to-Lever
1 - RETAINER (2)
2 - RELEASE LEVER
3 - RELEASE BEARING
Fig. 24 Release Bearing and Lever
1 - RELEASE LEVER
2 - RELEASE BEARING
(5) Reinstall transaxle assembly (Refer to 21 -
TRANSMISSION/TRANSAXLE/T 850 MANUAL -
INSTALLATION)
JR