Table of Contents
Advertisement
8R - 6
WIPERS/WASHERS
WIPER MOTOR (Continued)
(3) Remove one retaining nut to linkage crank to
motor shaft and remove crank.
(4) Remove the rubber grommet on shaft.
(5) Remove the three retaining bolts to linkage
assembly and remove motor.
INSTALLATION
(1) Remove nut and bolts from new motor.
(2) Connect motor to electrical connector, reconnect
battery, and cycle motor to park position.
(3) Disconnect negative battery cable and motor
electrical connector.
(4) Place motor on linkage assembly and place
motor retaining plate over motor shaft.
1 - WIPER MOTOR CRANK
2 - WIPER LINKAGE
3 - MOTOR RETAINING BOLT TO LINKAGE
Fig. 6 WIPER MOTOR CRANK ALIGNMENT
4 - CENTER OF BALL STUD TO CENTER OF MOTOR RETAINING BOLT - 27.6 MM
5 - BALL STUD IS ON THE MOTOR CRANK INSIDE THE CAP ON THE LINKAGE.
6 - WIPER MOTOR CRANK AND WIPER LINKAGE SHOULD BE PARALLEL WHEN IN THE
PARK POSITION.
(5) Install the motor retaining bolts. Torque bolts
to 9 ± 1 N·m (80 ± 9 in. lbs.).
(6) Install the motor shaft grommet.
(7) Align the crank with the linkage arm so it is
parallel (Fig. 6). The linkage arm will cover the hole
in the crank when aligned properly (Fig. 6). Place the
crank on the motor shaft and start the nut. Torque
the nut to 18 ± 2 N·m (159 ± 18 in. lbs.).
(8) Install the wiper motor assembly (Refer to 8 -
ELECTRICAL/WIPERS/WASHERS/WIPER MOTOR
ASSEMBLY - INSTALLATION).
(9) Connect the battery negative cable.
(10) Close hood.
(11) Verify vehicle and system operation.
JR
Advertisement
Table of Contents
