Cylinder Head Cover; Cylinder Head Cover Bolt Seals; Cylinder Head Cover Gasket And Spark Plug Well Seals; Spark Plug Well Seals - Chrysler Sebring 2004 Service Manual

JR
CAMSHAFT(S) (Continued)
Fig. 27 Cylinder Head Cover Bolt Seals
(6) Install camshaft target magnet and camshaft
position sensor.
(7) Install cylinder head cover (Refer to 9 -
ENGINE/CYLINDER
COVER(S) - INSTALLATION).
(8) Install rear timing belt cover and camshaft
sprockets (Refer to 9 - ENGINE/VALVE TIMING/TIM-
ING BELT / CHAIN COVER(S) - INSTALLATION).
(9) Install timing belt and front timing belt cover(Re-
fer to 9 - ENGINE/VALVE TIMING/TIMING BELT/
CHAIN AND SPROCKETS - INSTALLATION).

CYLINDER HEAD COVER

REMOVAL
(1) Remove ignition coil and plug wires.
(2) Disconnect PCV and make-up air hoses from
cylinder head cover.
(3) Remove the cylinder head cover fasteners.
(4) Remove cylinder head cover from cylinder head.
CLEANING
Clean cylinder head and cover mating surfaces
using a suitable solvent.
INSPECTION
Inspect cover rails for flatness.
INSTALLATION
NOTE: Replace spark plug well seals when install-
ing a new cylinder head cover gasket.
(1) Install new cylinder head cover gaskets (Fig.
25) and spark plug well seals (Fig. 26).
(2) Replace cylinder head cover bolt seals (Fig. 27).
HEAD/CYLINDER
CAUTION: Do not allow oil or solvents to contact
the timing belt as they can deteriorate the rubber
and cause tooth skipping.
Fig. 25 Cylinder Head Cover Gasket and Spark Plug

1 - SPARK PLUG WELL SEALS

2 - GASKET
HEAD
Fig. 24 Camshaft Bearing Cap Sealing
1 - 1.5 mm (.060 in.) DIAMETER BEAD OF MOPAR GASKET MAKER
ENGINE 2.0L DOHC
Well Seals
Fig. 26 Spark Plug Well Seals
9 - 31