Table of Contents
Advertisement
8L - 18
LAMPS/LIGHTING - EXTERIOR
HEADLAMP UNIT (Continued)
1 - CENTER OF VEHICLE
2 - CENTER OF HEADLAMPS
To adjust headlamp alignment, rotate alignment
screw to achieve the specified low beam hot spot pat-
tern.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the two retaining screws.
(3) Remove upper fascia retainers by prying under
the head of the fasteners with a flat bladed tool.
(4) Remove headlamp unit from fender side first,
then pull headlamp unit out.
(5) Disconnect the wiring harness from the bulbs.
(6) Remove the headlamp unit.
INSTALLATION
(1) Connect wire harness to the bulbs.
(2) Install headlamp unit.
(3) Install the retaining screws.
(4) Install upper fascia retainers.
(5) Connect the battery negative cable.
Fig. 20 HEADLAMP ALIGNMENT SCREEN
3 - FRONT OF HEADLAMP
HEADLAMP UNIT - EXPORT
STANDARD PROCEDURE - HEADLAMP UNIT
ALIGNMENT - EXPORT
HEADLAMP ALIGNMENT PREPARATION
(1) Verify headlamps are on low setting.
(2) Verify that the headlamp leveling switch is in
the "0" position.
(3) Inspect and correct damaged or defective com-
ponents that could interfere with proper headlamp
alignment.
(4) Verify proper tire inflation.
(5) Clean headlamp lenses.
(6) Verify that luggage area is loaded as the vehi-
cle is routinely used.
(7) Fuel tank should be FULL. Add 2.94 kg (6.5
lbs.) of weight over the fuel tank for each estimated
gallon of missing fuel.
ALIGNMENT SCREEN PREPARATION
(1) Position vehicle on a level surface perpendicu-
lar to a flat wall 10 meters (32.8 ft.) away from front
of headlamp lens (Fig. 21).
JR
Advertisement
Table of Contents
