Installation; License Plate Lamp Removal; License Plate Lamp Unit Removal - Chrysler 2004 Concorde Service Manual

LH
HEADLAMP UNIT (Continued)

INSTALLATION

CONCORDE/300M
CAUTION: Do not touch the glass of halogen lamps
with fingers or other possibly oily surface, reduced
bulb life will result.
NOTE: If replacing complete headlamp unit, transfer
lamps to new unit.
(1) Connect the lamp connectors.
(2) Maneuver the headlamp unit to under the
crossmember and behind fascia. Gentle prying of fas-
cia may be needed to clear it enough to install the
headlamp unit.
NOTE: Be careful not to scratch the fenders while
the crossmember is loose.
(3) Install fasteners to upper radiator crossmem-
ber:
• Gently pry back grille and install the two bolts
to front crossmember.
• Two jack screws on each side.
• Three push pin fasteners across top of grille.
• Three crossmember retaining bolts on each side.
(4) Install the two bolts retaining the speed control
servo.
(5) Install the one bolt retaining the washer bottle
filler neck.
(6) Connect and the battery negative remote cable.
(7) Verify headlamp operation and alignment.
(8) Close hood and check alignment of hood that it
is flush with the fenders.
INTREPID
NOTE: Headlamp lens fogging is a normal condition
and does not require service unless excessive or
continual. Moisture will vent from tubes or vents
located on the back of the lamp.
(1) Place headlamp unit in position on vehicle.
(2) Connect wire connectors to headlamp, parking,
side marker, and turn signal lamps.
(3) Place headlamp unit in position on body.
(4) Install screws to attach headlamp unit to body.
LAMPS/LIGHTING - EXTERIOR 8L - 31
(5) Connect the battery negative remote cable and
close hood.
(6) Verify headlamp operation and alignment.
LICENSE PLATE LAMP
REMOVAL
(1) Remove screws attaching license plate lamp to
rear bumper fascia.
(2) Remove license plate lamp from rear bumper
fascia.
(3) Remove socket from lamp (Fig. 36).
(4) Pull bulb from socket.
Fig. 36 LICENSE PLATE LAMP
1 - LICENSE PLATE LAMP
2 - TRUNK LID
3 - SOCKET
4 - BULB
INSTALLATION
(1) Push bulb into socket.
(2) Install socket into lamp.
(3) Place license plate lamp in position on rear
bumper fascia.
(4) Install screws to attach license plate lamp to
rear bumper fascia.
LICENSE PLATE LAMP UNIT
REMOVAL
(1) Remove screws holding license plate lamp to
fascia (Fig. 37).
(2) Remove license plate lamp from vehicle.