Table of Contents
Advertisement
JR
RADIATOR FAN(S) (Continued)
Fig. 33 RADIATOR FAN
1 - FAN MOTOR ELECTRICAL CONNECTOR
2 - CLIP - UPPER ATTACHING
3 - SCREWS - RIGHT SIDE
4 - CLIP - LOWER RETAINING (REMAINS ON RADIATOR)
5 - SCREWS - LEFT SIDE
INSTALLATION
(1) Install radiator fan to radiator. Install retain-
ing clip and tighten fasteners to 5 N·m (45 in. lbs.)
(Fig. 33).
(2) Connect radiator fan electrical connector.
(3) Install upper radiator crossmember.
THERMOSTAT HOUSING
REMOVAL
REMOVAL - 2.0L
(1) Disconnect negative battery cable.
(2) Partially drain cooling system below thermo-
stat housing level.
(3) Remove accessory drive belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL).
(4) Disconnect and remove generator.
(5) Remove thermostat (Refer to 7 - COOLING/
ENGINE/ENGINE
COOLANT
REMOVAL).
(6) Disconnect engine coolant temperature sensor
connector.
(7) Disconnect heater supply hose.
(8) Remove housing attaching bolts (Fig. 34).
(9) Remove housing and gasket (Fig. 34).
REMOVAL - 2.4L
(1) Partially drain cooling system below thermo-
stat housing level.
THERMOSTAT
-
(2) Remove thermostat (Refer to 7 - COOLING/
ENGINE/ENGINE
COOLANT
REMOVAL).
(3) Disconnect engine coolant temperature sensor
connector.
(4) Disconnect heater supply hose.
(5) Remove housing attaching bolts (Fig. 34).
(6) Remove housing and gasket (Fig. 34).
Fig. 34 Thermostat Housing
1 - THERMOSTAT HOUSING
2 - COOLING SYSTEM BLEED VALVE
3 - BOLTS
4 - ENGINE COOLANT TEMPERATURE SENSOR
INSTALLATION
INSTALLATION - 2.0L
(1) Clean all gasket sealing surfaces.
(2) Install gasket and housing (Fig. 34). Tighten
bolts to 28 N·m (20 ft. lbs.).
(3) Reconnect heater supply hose.
(4) Reconnect engine coolant temperature sensor
connector.
(5) Install thermostat (Refer to 7 - COOLING/EN-
GINE/ENGINE
COOLANT
INSTALLATION).
(6) Install generator. Reconnect generator connec-
tors.
(7) Install accessory drive belt (Refer to 7 - COOL-
ING/ACCESSORY DRIVE/DRIVE BELTS - INSTAL-
LATION).
(8) Fill cooling system (Refer to 7 - COOLING/EN-
GINE - STANDARD PROCEDURE).
(9) Connect negative battery cable.
ENGINE
7 - 41
THERMOSTAT
-
THERMOSTAT
-
Advertisement
Table of Contents
