Table of Contents
Advertisement
JR
COMPAPSS MINI TRIP
COMPUTER/TRAVELER
ILLUMINATION LAMP
REMOVAL
(1) Remove the CMTC/Traveler from the instru-
ment panel. Refer to Body, Instrument Panel, Com-
pass Mini-Trip Computer, Removal.
(2) With the CMTC removed from the cluster
bezel, remove the tape from the lamp access opening
at the bottom of the CMTC/Traveler.
(3) With a screwdriver, twist the bulb assembly 1/4
turn counterclockwise. Remove bulb and replace.
INSTALLATION
(1) With a screwdriver, twist the bulb 1/4 turn
clockwise.
(2) Install the tape to the access opening at the
bottom of the CMTC/Traveler to prevent any light
leaking.
(3) Install the CMTC/Traveler. Refer to Body,
Instrument Panel, Compass Mini-Trip Computer,
Installation.
CONSOLE COURTESY LAMP -
JR27 ONLY
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Using a flat bladed tool, gently pry lamp from
console (Fig. 2).
Fig. 2 CONSOLE COURTESY LAMP
(3) Disconnect wire harness connector.
(4) Remove bulb from lamp.
LAMPS/LIGHTING - INTERIOR
INSTALLATION
(1) Install bulb to lamp.
(2) Connect the wire harness connector.
(3) Press lamp into the center console.
(4) Connect the battery negative cable.
DOME LAMP
REMOVAL
(1) Disconnect and isolate battery negative cable.
(2) From the left side of the vehicle insert a flat
bladed pry tool under the lens (Fig. 3).
Fig. 3 DOME LAMP
1 - DOME LAMP BULB
2 - DOME LAMP
(3) Separate lamp from headliner.
(4) Disconnect wire harness connector.
INSTALLATION
(1) Connect wire connector to dome lamp.
(2) Center dome lamp in headlining opening.
(3) Push upward on dome lamp to engage it to the
headliner.
(4) Connect battery negative cable.
DOME LAMP BULB
REMOVAL
(1) Disconnect and isolate battery negative cable.
(2) From the left side of the vehicle, insert a flat
bladed pry tool under the lens.
(3) Remove bulb.
INSTALLATION
(1) Insert bulb into lamp.
(2) Push lens into place.
(3) Connect battery negative cable.
8L - 29
Advertisement
Table of Contents
